ISO INTERNATIONAL STANDARD 10605 Third edition 2023-06 Road vehicles Test methods for electrical disturbances from electrostatic discharge Vehicules routiers - Méthodes d'essai des perturbations électriques provenant de décharges électrostatiques Reference number IS0 10605:2023(E) ISO @ IS0 2023 IS0 10605:2023(E) COPYRIGHT PROTECTED DOCUMENT @IS02023 All rights reserved. Unless otherwise specified, or required in the context of its implementation, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on orIso'smemberbodyinthecountryoftherequester. ISO copyright office CP 401 · Ch. de Blandonnet 8 CH-1214 Vernier, Geneva Phone: +41 22 749 01 11 Email: [email protected] Website: www.iso.org Published in Switzerland ii @IS0 2023 - All rights reserved IS0 10605:2023(E) Contents Page Foreword Introduction vi 1 Scope. .1 2 Normative references .1 3 Terms and definitions .1 4 Test conditions. .2 5 Test location. .3 6 Test apparatus and instrumentation .3 6.1 ESD generator 3 6.2 Discharge tips. 6.2.1 Contact discharge tip. 3 6.2.2 Air discharge tip 4 6.3 Discharge current specifications 55 6.3.1 Contact discharge mode current specifications 6.3.2Air dischargemode current specifications. 6 6.4 Ground plane 6 6.5 Field coupling plane 7 6.6 Insulating block 7 6.7 Dissipative mat. 7 6.8 Uncertainty (informative) 7 7 Discharge modes. 7 7.1 General. 7 7.2 Contact discharge mode 7 7.3 Air discharge mode. 7 8 Component immunity test method (powered-up test) .8 8.1 General. .8 8.2 Test plan .8 8.3 Test procedure for direct discharges .8 8.3.1 General .8 8.3.2 Test set-up .8 8.3.3 Test method 11 8.4 Test procedure for indirect discharges. 12 8.4.1 General 12 8.4.2 Test set-up. .12 8.4.3 Test method 15 Component packaging and handling test method (unpowered test) 16 9 9.1 General. 16 9.2 Test plan 16 9.3 Test procedure 16 9.3.1 General 16 9.3.2 Test set-up 17 9.3.3 Test method 18 10 Vehicle test method 19 10.1 General. 19 10.2 Test plan 19 10.3 Test procedure 19 10.3.1 General 19 10.3.2 Test set-up 19 10.3.3 Test method 21 11 Test report. 21 @ IS0 2023 - All rights reserved ili